After heat-curing, the mandrel is removed, leaving a hollow tube. From Wordnik.com. [The Home-Built Rod] Reference
A mandrel is a spindle or metal shaft around which other parts rotate. From Wordnik.com. [Total WonKerr] Reference
A very economical method of clamping is that on the mandrel, which is also called expansion arbor. From Wordnik.com. [4. Preparation of the work on the regular engine lathe] Reference
A wooden mandrel is prepared of the proper size and shape. From Wordnik.com. [On Laboratory Arts] Reference
The next step would be to turn out a bore and fit a mandrel into it. From Wordnik.com. [Practical Mechanics for Boys] Reference
Cylinder (mandrel-drawn brass tubing), 1-1/2 inches internal diameter. From Wordnik.com. [Things To Make] Reference
The wrapping mandrel is slipped on the wrap pin with the central hole. From Wordnik.com. [4. Wire-wrap Joints] Reference
The discs are made by pouring lead round the screw-nose of the mandrel. From Wordnik.com. [On Laboratory Arts] Reference
REILLY: It's like sort of intimidating like I imagine a mandrel would be. From Wordnik.com. [CNN Transcript Dec 25, 2006] Reference
In mounting a hollow section, or in drilling, only a mandrel should be used. From Wordnik.com. [1. The workbench] Reference
The disc is, of course, mounted on the mandrel, and the work on the slide-rest. From Wordnik.com. [On Laboratory Arts] Reference
Flat sections are manually rolled with the rolling mandrel or on the rolling device. From Wordnik.com. [5. Bending Techniques] Reference
The projecting ends of the mandrel are supported to allow the worm to lie quite clear. From Wordnik.com. [Fire Prevention and Fire Extinction] Reference
THAT is because of the fun and love I found in the torch and glass rods and the mandrel. From Wordnik.com. [Making Light: Open thread 136] Reference
These are two of the eggs that I made in the same off-mandrel lampworking technique class. From Wordnik.com. [Kater’s Art » Blog Archive » Eggs One and Two] Reference
The mandrel is then forced in by the hammer until its lower edge has passed through the hoop. From Wordnik.com. [Scientific American Supplement, No. 488, May 9, 1885] Reference
If the small mandrel be not used the heads of the rivets are apt to lie unequally on the worm. From Wordnik.com. [Fire Prevention and Fire Extinction] Reference
Well then, you will need a 7mm mandrel, a set of bushings, a 7mm drill bit and barrel trimmer. From Wordnik.com. [What A Bargain] Reference
All graphite rods have what's called a spine, where the graphite wrap ended around the mandrel. From Wordnik.com. [The Home-Built Rod] Reference
I made these in an off-mandrel technique class I took at the Mest Art Center from Laurie Nessel. From Wordnik.com. [Kater’s Art » Blog Archive » Amber nests, one and two] Reference
Do not make the too common mistake of running the mandrel at high speeds in your initial tests. From Wordnik.com. [Practical Mechanics for Boys] Reference
This device consists of a mandrel carrying at one end the cutter and at the other end a large pulley. From Wordnik.com. [Scientific American, Volume XLIII., No. 25, December 18, 1880 A Weekly Journal of Practical Information, Art, Science, Mechanics, Chemistry, and Manufactures.] Reference
The saw is put on the mandrel at an angle, as will be seen, and should be run at a high rate of speed. From Wordnik.com. [Practical Mechanics for Boys] Reference
The jacket was made by coiling a bar over the mandrel in a spiral, then hammering the coils into a welded cylinder. From Wordnik.com. [Artillery Through the Ages A Short Illustrated History of Cannon, Emphasizing Types Used in America] Reference
If very accurate spools are needed the mandrel is better made of iron or slate and the spool is turned up afterwards. From Wordnik.com. [On Laboratory Arts] Reference
This method is very handy with small lenses; the mandrel is turned, and the lens adjusted by hand till the images are immovable. From Wordnik.com. [On Laboratory Arts] Reference
The cylinder and piston are made from mandrel drawn brass tubing, which may be purchased in any desired quantity in New York city. From Wordnik.com. [Scientific American, Volume XLIII., No. 25, December 18, 1880 A Weekly Journal of Practical Information, Art, Science, Mechanics, Chemistry, and Manufactures.] Reference
In general, as the lathe is rotated by turning the mandrel the image of the illuminated cross wires will be observed to rotate also. From Wordnik.com. [On Laboratory Arts] Reference
Finally the tube is bound round the mandrel with sufficient force to bring it to the proper shape and boiled in water, mandrel and all. From Wordnik.com. [On Laboratory Arts] Reference
LearnThatWord and the Open Dictionary of English are programs by LearnThat Foundation, a 501(c)3 nonprofit.
Questions? Feedback? We want to hear from you!
Email us
or click here for instant support.
Copyright © 2005 and after - LearnThat Foundation. Patents pending.