Discussion about math, puzzles, games and fun. Useful symbols: ÷ × ½ √ ∞ ≠ ≤ ≥ ≈ ⇒ ± ∈ Δ θ ∴ ∑ ∫ π -¹ ² ³ °

You are not logged in.

- Topics: Active | Unanswered

**Nickm62388****Member**- Registered: 2021-06-30
- Posts: 2

I have the answer to these two problems, but cannot figure out how they were got, and cannot find a formula or anything online to get the answer please help

Problem #1

17ft. 7 1/2in.

- 14ft. 9 7/8in.

=??????????

Problem #2

59degrees 37’ 18”

- 40 degrees 43’ 22”

=????? I don’t understand how you subtract something with degrees and feet and inches

Again I have the answers from the answer key but no idea how the answers came to be…

Please help

Offline

**ganesh****Administrator**- Registered: 2005-06-28
- Posts: 34,580

Hi Nickm62388,

**Welcome to the forum!**

Please see the links:

It is no good to try to stop knowledge from going forward. Ignorance is never better than knowledge - Enrico Fermi.

Nothing is better than reading and gaining more and more knowledge - Stephen William Hawking.

Offline

**Nickm62388****Member**- Registered: 2021-06-30
- Posts: 2

I appreciate the links, but with the equations I listed. I don’t see how exactly they relate or help answer them with the links. //

Offline

**phrontister****Real Member**- From: The Land of Tomorrow
- Registered: 2009-07-12
- Posts: 4,695

Hi Nickm62388;

Here's my way of tackling these (others may have different methods).

**Problem #1**

The inches & fraction components in the first length are less than their counterparts in the second length, which adds difficulty to subtracting imperial lengths, particularly those with fractions.

To make the subtraction easier, I start with the following three steps:

1. convert the fraction to the Least Common Denominator (LCD); then

2. adjust the value of the fraction component to make it greater than that of the second length; then

3. adjust the value of the inches component to make it greater than that of the second length.

That leaves a simple subtraction exercise.

Btw, the 'take' and 'add' terminology that I used is like 'borrow' and 'pay', now aka 'regrouping', and is how I've always understood that concept.

Also, I've used symbols ' and " instead of abbreviations 'ft' and 'in' respectively...a common notation practice for these imperial length units.

Formula: You could convert both lengths to eighths of an inch, deduct the second from the first, and convert the result to feet, inches and eighths:

That last conversion from eighths is a bit tricky...

**Problem #2**

Same approach as for Problem #1:

Formula: You could convert both angles to seconds, deduct the second from the first, and convert the result to degrees, minutes & seconds:

*Last edited by phrontister (2021-09-10 11:33:29)*

"The good news about computers is that they do what you tell them to do. The bad news is that they do what you tell them to do." - Ted Nelson

Offline