A voltage of about 50 kV is applied to the electrodes.    From Wordnik.com.  [6. Electrical Field] Reference

Rescue of injured people out of electric plants under 1 kV.    From Wordnik.com.  [3. Recommendations for Practical Vocational Training in the Working Techniques Required for ''Acting After Accidents Caused by Electric Current''] Reference

Rescue of Injured People out of Electric Plants below 1 kV.    From Wordnik.com.  [2. Rescue of Injured People out of Electric Plants below 1 kV] Reference

Fig. 4 Simplified equivalent circuit of overhead lines up to 60 kV.    From Wordnik.com.  [1. Swer, a low cost rural distribution system using single wire earth return.] Reference

Their range of performance extends up to 1500 MVA and a voltage of 10.5 kV.    From Wordnik.com.  [4. Synchronous machines] Reference

For example, a voltage of 330 kV can break through an distance in air of about.    From Wordnik.com.  [6. Electrical Field] Reference

Example for making of lines for use in heavy current installations of up to 1 kV.    From Wordnik.com.  [3. Connection of Cables and Lines for Fixed Laying to Electrical Equipment] Reference

The high voltage winding can be connected to either 25.4 (12.7) or 12.7 (6.35) kV.    From Wordnik.com.  [1. Swer, a low cost rural distribution system using single wire earth return.] Reference

Urban network transformers are transformers whose undervoltage is less than 1 kV.    From Wordnik.com.  [8. Transformer] Reference

All the voltages are shown for a 22 kV main distribution (and in brackets an 11 kV).    From Wordnik.com.  [1. Swer, a low cost rural distribution system using single wire earth return.] Reference

The figure you post is very misleading in that it does not show AC lines below 500 kV.    From Wordnik.com.  [Matthew Yglesias » An Electrical Grid We Can Believe In] Reference

For 25.4 (12.7) kV end a rating of 100 kVA the maximum earth return current is 4 (8) A.    From Wordnik.com.  [1. Swer, a low cost rural distribution system using single wire earth return.] Reference

Installation (plant) engineering is only dealt with in the low-voltage range of up to 1 kV.    From Wordnik.com.  [Chapter 2] Reference

At 12.7 (6.35) kV, however, only the 480V winding is used (see Fig 4a), which will produce 240V.    From Wordnik.com.  [1. Swer, a low cost rural distribution system using single wire earth return.] Reference

Direct-current high-speed switches are manufactured for voltages up to 3 kV and currents of 3000.    From Wordnik.com.  [3. Low-voltage circuit breakers] Reference

The 22 (11) kV single phase transformer would be similar except that it would have two HV bushings.    From Wordnik.com.  [1. Swer, a low cost rural distribution system using single wire earth return.] Reference

(T = isolating switch, C = three-pole, I = indoor) which is also manufactured for 1 kV, can be used.    From Wordnik.com.  [3. Low-voltage circuit breakers] Reference

Above 60 kV the capacitance between the wires as well as between wires and ground have to be considered.    From Wordnik.com.  [1. Swer, a low cost rural distribution system using single wire earth return.] Reference

The protective insulation must stand an alternating current test voltage of 4 kV for at least one minute.    From Wordnik.com.  [Chapter 4] Reference

Installation systems are being installed in the low voltage range up to 1 kV ac voltage and 1.5 kV dc voltage.    From Wordnik.com.  [5. Fundamentals of installation engineering] Reference

Low-voltage circuit breaker Load-break switch Isolating switch Earthing switch Power circuit breaker up to 30 kV.    From Wordnik.com.  [2. Important components of switches] Reference

As unit of the voltage, the volt - V - has been laid down; the most frequently used sub-units are MV, kV and µV.    From Wordnik.com.  [2. Fundamental Quantities of Electrical Engineering] Reference

A step-up transformer (11) outside the power house is required to transport electricity via the 6 kV transmission line.    From Wordnik.com.  [1. SALLERI-CHIALSA MICRO HYDEL PROJECT, NEPAL] Reference

This implies the installation of a second generating unit and the extension of the 11 kV lines of today 10 to about 20 kin.    From Wordnik.com.  [1 Introduction] Reference

The 11 kV lines, with a length of roughly l0km, supply a distribution grid which was built up step by step from 1987 to 1990.    From Wordnik.com.  [1 Introduction] Reference

A high-tension transmission line of 11 kV will be necessary for this purpose and will also make supply to other villages possible.    From Wordnik.com.  [1. SALLERI-CHIALSA MICRO HYDEL PROJECT, NEPAL] Reference

Where 12.7 (6.35) kV connections are used, the earth currents return to the supply transformer neutral (distribution concept Fig 1 c).    From Wordnik.com.  [1. Swer, a low cost rural distribution system using single wire earth return.] Reference

Long SWER spurs with loadings in excess of 5070 kVA could be supplied via a 22/25.4 (11/1 2.7) kV insulating transformer (see Fig 1d).    From Wordnik.com.  [1. Swer, a low cost rural distribution system using single wire earth return.] Reference

Touchscreen Controller features ±15 kV ESD protection.    From Wordnik.com.  [ThomasNet Industrial Newsroom - Today's New Product News] Reference

The standard refers to a contact ESD of 8 kV or an air ESD of.    From Wordnik.com. Reference

Optical Isolator offers 16 kV isolation at 2 Mbd data transfer.    From Wordnik.com.  [Engineering Hardware-Software] Reference

There is a 55 kV line that runs within a few hundred meters of the lease boundary.    From Wordnik.com.  [Marketwire - Breaking News Releases]

Grids were observed using a Zeiss EM9 transmission electronic microscope at 80 kV.    From Wordnik.com.  [PLoS ONE Alerts: New Articles] Reference

PPC has a modern plant already equipped to produce high voltage cables up to 220 kV.    From Wordnik.com.  [Releases feed from RealWire]